Friday, April 17, 2015

How to Remove Brake Rotors From an Isuzu Rodeo

How to Remove Brake Rotors From an Isuzu Rodeo

The brake rotors on your Isuzu Rodeo may wear too thin, crack or get scored after years of service. Being one of the most important safety components on your vehicle, a worn-out or damaged rotor should be replaced as soon as possible. It is a job you can do yourself using some simple tools and these steps.

Instructions

Remove the Brake Caliper

    1

    Park your Isuzu in a safe place with a level surface, if possible.

    2

    Loosen the wheel lugs using a lug wrench on the wheel assembly with the brake rotor you want to replace.

    3

    Raise the wheel assembly and tire off the floor using a floor jack.
    Support the vehicle on a jack stand.
    Remove the tire.

    4

    Set a C-clamp over the brake caliper and turn in the C-clamp screw to push the brake caliper cylinder into its bore.

    5

    Remove the two brake caliper mounting bolts, using a wrench or ratchet and socket and lift the caliper off the brake rotor.

    6

    Secure the brake caliper on the vehicle body using a piece of wire to avoid damage to the brake hose connected to the caliper.

    7

    Remove the two caliper bracket mounting bolts, if your Isuzu model is equipped with it. Then lift the caliper bracket off the rotor.

Replace the Rotor

    8

    Remove the brake rotor by pulling the unit off the wheel assembly by hand. If the rotor seems stuck, tap the rotor lightly around the friction surface, using a rubber mallet to pop it out from the wheel assembly.

    9

    Wipe the hub and wheel assembly clean of brake lining dust using brake parts cleaner and a shop rag.
    Remove the protective film off the new rotor surface using denatured alcohol and a clean rag.

    10

    Install the new rotor on the hub and wheel assembly.

    11

    Install the brake caliper mounting bracket if your Isuzu model is equipped with one.
    Install the brake caliper.

    12

    Install the tire and wheel lugs.

    13

    Lower the vehicle.
    Finish tightening the wheel lugs.

    14

    Add brake fluid to the brake master cylinder.
    Depress the brake pedal several times to adjust the brake pads over the new rotor.

Related Posts by Categories

0 comments:

Post a Comment